Findmall.com
 
 






Minelab Excalibur & Sovereign Forum


Welcome! Log In Register
Re: Two steps to success when wiring up a coil on the Excalibur.
Posted by: OldBeechnut
Date: April 23, 2015 10:57PM
Quote
mel
2) With the unit powered up in the all metal/ pinpoint mode pass an iron object over the center of the coil, if it nulls or goes quiet the transmit wires are reversed. Power the Excal down and reverse the transmit wires.

I came across several SEFs last year that were wired up wrong and if you ran anything metal, with the machine in PP, across the center, it would go beep before it hit the center, then null as it passed the center then beep again. (inverted signal) I checked the chart that was out and all was wired to the chart but the chart was wrong...black n gray were reversed, once swapped all was back to normal. But amazing the coils were wired by XXXX and the hunters continued to use and never noticed. In Disc it is harder to notice....so I guess they hunted in disc all the time. I did bring it to the attention of and was told the company had wired the coils wrong....? And was asked not to say anything.



2017 .. Gold Rings 134..........Silvers 176


SubjectAuthorViewsPosted

Two steps to success when wiring up a coil on the Excalibur.

Mel Parker4282April 23, 2015 09:26PM

Re: Two steps to success when wiring up a coil on the Excalibur.

dewcon4414562April 24, 2015 04:16AM

Re: Two steps to success when wiring up a coil on the Excalibur.

Golchaser467September 17, 2015 10:25PM

Re: Two steps to success when wiring up a coil on the Excalibur. URL

Ruslan430February 01, 2016 04:18PM

Re: Two steps to success when wiring up a coil on the Excalibur.

OldBeechnut642April 23, 2015 10:57PM

Re: Two steps to success when wiring up a coil on the Excalibur.

bklein127April 29, 2017 10:24AM

Re: Two steps to success when wiring up a coil on the Excalibur. Jpeg Attachments URL

Ruslan150June 14, 2017 02:28PM



Sorry, only registered users may post in this forum.

Click here to login