Findmall.com
 
 






Minelab Excalibur & Sovereign Forum


Welcome! Log In Register
Re: End Cap connector choices
Posted by: OldBeechnut
Date: March 26, 2017 09:27PM
Thanks B! The stock caps are cast so they tend to fracture in time. I would go with the heyco's first then down the road I can do you a couple blank endcaps. Then you can go from there and modify them as needed. Also one little tip, go the 3M SS M12-4 pins. I've been testing the composite type the last few months and seems to be a issue with falsing when swing in saltwater. I also went with the composite on the coil end, then the SS female set in the endcap and the same issue. Seems the best setup is all SS... So a 3M M12-4 set in the endcap and a 3M M12-4 pin for the coil side also. Good Luck



Effort is Important, But knowing where to make an effort can make all the difference!


SubjectAuthorViewsPosted

End Cap connector choices

bklein310March 26, 2017 05:32PM

Re: End Cap connector choices

OldBeechnut210March 26, 2017 09:27PM



Sorry, only registered users may post in this forum.

Click here to login