Findmall.com
 
 






Fisher CZ Forum


Welcome! Log In Register
CZ-5 meter / discrimination question...
Digger
Date: January 16, 2005 12:30AM
I have a few questions regarding my CZ-5. 1. the meter and tones register correctly on most targets. However, the meter stays at the position of the last target until a new target is detected. Then it indicates the new target. Is that normal? 2. When trying to set up my discrimination to allow V-nickels and Shield nickels, discrimination level 2 gives a mid tone and the meter shows as foil. I find that I cannot accept them (or a small gold ring) if I set the discrinimation level at position higher than 2 while in normal mode. Is this normal? 3. If I switch to salt mode, I can detect the V nickles and Shield nickels at discrimination level 3, and they ID as nickels with a high tone. Is this normal? Thanks in advance for your response. HH

Unfortunately...
Dan-Pa.
Date: January 16, 2005 08:43AM
V-shield and even some Buffalo come in low and may hit nickel or have a foil to nickel bounce as their mineral content is different than a Jefferson nickel.
CZ3D has expanded their nickel facet to correct this situation. Sounds like your CZ5 is working fine to me judging by your post and not actually having it in hand to test...

Thanks Dan. How about the ......
Digger
Date: January 16, 2005 05:38PM
meter needle hanging on to a reading until I pass over a new target? Is that normal? I figured the needle would return to zero between targets, not stick on the latest reading. Actually though, I kind of like it staying put. Makes target ID faster when I don't have to pass over the signal a couple times. Thanks.

Re: Thanks Dan. How about the ......
Charles Prunty
Date: January 16, 2005 05:52PM
That's just how the CZ's work, it will stay there till you hit a new target. So yes that is normal, nothing wrong with it.

Charles is right on..
Dan-Pa.
Date: January 16, 2005 08:45PM
Every CZ I ever had worked that way....

Thanks guys.
Digger
Date: January 17, 2005 12:09AM
Sorry, only registered users may post in this forum.

Click here to login