Findmall.com
 
 






Vintage Detecting Forum


Welcome! Log In Register
Big Bud Pro Select 220 D
Posted by: umax
Date: July 24, 2017 10:25AM
This detector works in all functions perfect. With any type of coin on the ground it gets excellent depth. What I have noticed is, let's say it will detect a coin at 8 inches with the discrimination set to except Nickles and all other coins and the notch features off, after 8 inches or so, the detector will reject the coins and lower the coil and the detector will accept the coins. Any input on what causes this.

Re: Big Bud Pro Select 220 D
Posted by: Tom_in_CA
Date: July 24, 2017 03:27PM
I'm having a hard time understanding your question. But it sounds like you're saying that ....... beyond 8", you start to loose the signal. Right ? And by "loose the signal", I'm guessing that's why you mean by "rejects" ? If so, then this is merely because at 8", you've gotten to the max depth you could hope to get (for that size object and the control settings you've chosen). Hence anything deeper than that is un-classified. The machine can't TID might still be getting it, but not enough signal strength to classify it as iron, or low or mid or high conductor. Thus you might get a flicker of the needle (or a reject sound or whatever) when you've gone over 8", because you are beyond the machine's ability to put into proper ID.

Am I understanding your question correctly ?

Re: Big Bud Pro Select 220 D
Posted by: umax
Date: July 24, 2017 06:21PM
Around 7 to 8 inches a strong signal and after this height the siginal is still strong but the detector is discriminating the coins out. I lower the coil and around the 8 inch mark the detector accepts the coins as good, go higher and the detector rejects, be it by sound or meter with notch turned off.

Re: Big Bud Pro Select 220 D
Posted by: Tom_in_CA
Date: July 24, 2017 09:05PM
I'm still having a bit of a problem understanding your question. But perhaps that machine has what's called a signal boost (or various terminology to that effect). What that means, is that some machines amplify ALL signals to equal loudness. As opposed to shallow ones sounding "louder" and deeper ones being "whispers". The manufacturers who implemented this on some machines over the years did so with the notion that this would help persons to "hear the whispers". So there's no more graduating loud vs whisper distinctions. All signals sound the same. So in order to know depth, all you can do is look at the depth meter, or cross-check in all-metal pinpoint mode. Or raise the coil to see when the signal stops, etc...

Most md'rs found this very annoying. Because you would loose all sense of deep vs shallow. Everything start to sound the same.

I am thinking this is what you're referring to, since you allude to how the signal is "still strong" even to the 7 or 8" level. But then ... presto, it just rejects or disappears the moment you reach a certain depth. Right ? So that just means you have a given magical point at which it's "loud" versus when it "disappears" . There's no middle ground. I find that VERY ANNOYING.

If so, then see if there's a way to turn off your signal boost (or whatever the B.B. pro might call it). So that you will have a graduating weaker and weaker signal, as you go from 1" to 3", to 5", to 7", and so forth. You will still loose the target at a certain depth ("rejects" or "disappears" or whatever you want to call it).

have I understood you correctly ?

Sorry, only registered users may post in this forum.

Click here to login