Findmall.com
 
 






Teknetics Forum


Welcome! Log In Register
Detector Modifications
Posted by: all iron
Date: November 09, 2010 08:17AM
If a guy needed to send his detector in for repairs, could the manufacturer adjust certain aspects of a detectors sensitivity?
I have the delta 4000 and i was wondering if the A1 mode could be adjusted slightly to make it more friendly.

all iron, about the A1 and A2 All Metal modes of the Delta.
Posted by: Monte
Date: November 09, 2010 02:59PM
Quote
all iron
I have the delta 4000 and i was wondering if the A1 mode could be adjusted slightly to make it more friendly.
I am sure that during a check up they would make certain all modes and features functioned properly. As for the A1 All Meta mode being "unfriendly," I'd guess that you lower the coil towards the ground and it sounds off. If so, that simply suggests that the A1 mode has a preset Ground Balance that is positive enough to deal with some very challenging ground. If so, the A2 All Metal mode might perform a lot better as lowering the search coil (or raising it abruptly from the ground) ought to remain relatively smooth. The reason is that the A2 All Metal mode relies on a preset GB that might be closer to what you would have adjusted for if manually set.

The two All Metal modes do work differently, and I try to use A1 when possible, but if not, I opt for A2 and enjoy the hunt.

Monte


Sorry, only registered users may post in this forum.

Click here to login