Findmall.com
 
 






Teknetics Forum


Welcome! Log In Register
T2 Manual Ground Balance
Posted by: TheDirtKing
Date: July 18, 2017 01:39PM
When manually ground balancing the T2 Classic, I have seen some recommendations to lower sense to about 25 and disc to zero before performing the ground balance and other recommendations that didn't have the sensitivity dropped that low prior. What is the benefit, if any, of dropping the sensitivity low prior to manually ground balancing?

Thanks, ~DK

avatar
Re: T2 Manual Ground Balance
Posted by: Mega
Date: July 18, 2017 02:21PM
Must admit cannot recall the last time i was unable to Ground Grab with my T2,sometimes if i am using a very large and it does not GB i just leave it in factory default,if i am honest i would have too think how to do a manual GB on my T2.If i am on a pasture site that has had animals grazing for decades and animal dropping cause issues with doing a GB then i just leave it once again at factory default.



Deus and Nexus MP main everyday detectors

Displays on a Detector are really the equivalent of relying on sub-titles,give me a Analogue machine anyday.

Site specific use machines.
TDI Pro 20'' Mono
Nexus SE dual 9'' coil
Fisher TW-5 twin box
Crossbow PI Coiltek 14x9 Mono
Mirage PI 5'' Mono
DFX 18'' Detech
T2 SEF15x12
IDX Pro 15'' Concentric
Arado120b
B1 and B3
Trident11 Extreme NEL Snake


Mainly hunt deep ploughed and pasture sites,trashy roman/saxon and celtic permissions.

Sorry, only registered users may post in this forum.

Click here to login