Findmall.com
 
 






Bounty Hunter Forum


Welcome! Log In Register
Using a Quick Draw II in the woods
Posted by: mtnjak
Date: June 21, 2007 09:57PM
This is my first post to a site like this and my first detecting I did today with my new Quick Draw II. My wife and I went to our engagement spot for a picnic. I took the detector just for fun and ended up finding my first treasure - a pull tab. Yahoo. Anyways, it was spot on accurate in location and depth. Feeling lucky, we went home and I began hunting in our woods. We have 5-1/2 acres in East Peoria, IL. and a walking/biking path. To make it easy, we started on the path so as not to get into too much brush and weeds. The detector was behaving eratically high/low tones here and there. I used my pouch tool at first but then I was getting 8 inch depths so I grabbed my full size spade. Every time I dug - nothing. We continued this off/on for about an hour in several spots. It's almost as though there was a mole with braces playing games with us! I thought I found a spot and then dug down the suggested depth. Then I grabbed the detector again and sure enough the spot moved! It kept "moving" and I kept getting lower tones indicating iron/pull tabs (mostly the far left on the indicator). Occasional higher tones on the middle to right (25 cents area). The depth readout was usually around 4-6 inches. There are no power lines or antennas anywhere near our place. We are 300 feet to the nearest house.

Feeling a little discouraged now I'm wondering if anyone has any tips they can lend to a beginner. I did adjust the sensitivity and had it turned all the way down (counter-clockwise) at times. If I turned it up (clockwise) the reading depth would go up to 8 inches. I don't know if there could be something buried pretty deep or not. I'm using the stock 8" coil.

Finally, could it be possible that the detector could be reading old buckshot from shotgun hunters? We do have quite a bit of deer where we live. The lot is at the rear of a small subdivision. Before the subdivision was built, it was a farmer's field with wooded spots at the rear of the field (where we are). I just assume that people have probably hunted here at one time in the past.

Jason
East Peoria, IL

avatar
Re: Using a Quick Draw II in the woods
Posted by: jeff@middlesex
Date: June 22, 2007 05:32AM
Jason sounds like you had a pretty decent start and had the same start most of us did the first time out. Set your sensitivty at 2 oclock and the disc at 10 oclock. The 2 and 10 setting is like a standard to get started on till you get used to the sounds. Now speaking of sounds. You only want to dig targets that have the same sound or tone in both directions of the swing. So if you go over the target and you get a high tone one way and a low tone the other it is trash. If you get a tone one way and no tone or a broken tone in the other direction. It is also trash. Good targets sound the same in both directions of the swing. Now a couple other things to look for. On your target ID meter. Good sounding targets will make the cursor on the meter lock on a certain place. Trash targets will make the ID meter jump around. So something to always look for. When you get a good tone both directions as you swing over the target. Glance at the ID meter. If it locks dig, if it jumps around keep walking. Thats some info to get you started anyway

Re: Using a Quick Draw II in the woods
Posted by: mtnjak
Date: June 22, 2007 08:55AM
Thanks, Jeff.
I'll try that.

Jason

Sorry, only registered users may post in this forum.

Click here to login