Findmall.com
 
 






Minelab SD, GP, & GPX Classroom Forum


Welcome! Log In Register
Iron Reject??????
Posted by: Jim Robertson
Date: September 17, 2013 08:06AM
I have a question on iron reject. If you are running with iron reject wide open on 10 what else is being effected/ I guess what I am wondering are small targets being tuned out? ie. Brass targets and small deep targets

Re: Iron Reject??????
Posted by: filternozzle
Date: September 17, 2013 12:26PM
Some non-ferrous targets will give an iron type signal with Iron Reject set high.



Happy Hunting
Minelab GPX-5000 - Backup GPX-4500 with a very large selection of coils.



Edited 1 time(s). Last edit at 09/17/2013 12:27PM by filternozzle.

Re: Iron Reject??????
Posted by: iron bark
Date: September 18, 2013 04:38AM
Hi Jim run iron reject between 2 to 4 what size coil are you using

Re: Iron Reject??????
Posted by: Jim Robertson
Date: September 18, 2013 08:27PM
Stock 11 inch or 12X15 both DD

Re: Iron Reject??????
Posted by: iron bark
Date: September 19, 2013 12:54AM
Stick with the 11 coil on 2 to 4 until you are confident with it . The 15s are good but they are a little heavy ,I have used a 10 x 5 M/L and I was surprised at the depth and how good it was that was on a 4500 I found with the disc up high it would cut targets out
regards john

Thanks for the help.N/T
Posted by: Jim Robertson
Date: September 19, 2013 07:57AM

(This message does not contain any text.)


Re: Iron Reject??????
Posted by: ali5844
Date: December 20, 2016 12:05AM
Back light- Off - 3
Volume Limit- 19 - 17
Ground Balance Type- General - same Special- Sensitive Extra - same
Manual Tune- Range between 90 & 100, usually 95 - 96 (10 above is someone else is close, 10 below if EMI occurs) Deep- Motion slow - same
RX gain- 7 (This can vary depending on atmospheric conditions) - same Audio- Normal - Deep
Audio tone- 50 - 32
Stabiliser- 6 (This varies with RX gain) -
8 Signal- 19 - Same
Target volume- 12 - 16
Reponse- Normal - same
Tracking- Medium - Slow
Iron reject- Off - 10

Sorry, only registered users may post in this forum.

Click here to login