Findmall.com
 
 






Minelab EQUINOX Forum


Welcome! Log In Register
EQ screen indicators???
Posted by: jas415
Date: December 18, 2017 08:56AM
On the screen there is a outer 180 degree circular 'bar' and on many of the screen shots it is not continuous, and on some it is continuous. On a couple of the videos there is enough of a 'screen shot' to see it is varying. There looks to be 5 segments of it. What does that do? What is the function and what does it tell me as I am swinging it across the ground?

Thanks

Re: EQ screen indicators???
Posted by: Bourneredi
Date: December 18, 2017 09:09AM
I believe that’s to show what you’ve set your discrimination at. It shows what readings will be accepted and what will be rejected so that if you want to notch out certain readings you can. For instance you can have the detector ignore those readings.that you don’t want, say iron.

Re: EQ screen indicators???
Posted by: jas415
Date: December 18, 2017 09:47AM
So, going from lower left up and over to lower right, it would be from -9 to 0 on the first segment, then 10-20, 20-30, 30-40, and 40 to 50 on numbers. On some videos the very first segment was totally clear, so I assume that was to notch out 'all' iron? If it is all notched out, there would be no audio or '-' numbers. On the Dr Tones video of the coin find there is no discrimination at all as all segments are black, and when he is swinging it around I see the numbers go from -9 to positive numbers but lots of '-' numbers. Those would be iron or ferrous of some sort. Ok, makes sense.

Thanks! Sure hope they have a small coil right off the bat!

Re: EQ screen indicators???
Posted by: TomNH
Date: December 18, 2017 10:58AM
The scale is the same as on the Safari (-9 to 40). Assuming it reads the same -9 to 0 is iron
40 is almost always a rusty nail. IIRC nickel is 14, pennies mid 30's, clad 38, silver 39. there is
some overlap at times. Also it seems to have an option for 50 tones. If so you can make it sound like
a Safari. That should make transition easy for me.

73
Tom
LFOD !

Sorry, only registered users may post in this forum.

Click here to login