Findmall.com
 
 






Minelab Excalibur & Sovereign Forum


Welcome! Log In Register
avatar
Re: Question before sending in my Excalibur 1000
Posted by: bootyhoundpa
Date: June 10, 2019 05:11PM
I had trouble a few years ago with my 1000 too...my problem was in the original wiring... even though the outside cable looks good those individual wire insulation’s break causing all kinda problems from silence to constant noise... I would give it a full charge then turn it on and manipulate the cables seeing if you can pinpoint a wiring issue... I replaced my headphones with Mals surf phones and put a nel thunder coil on it...I’m very happy with that combo.. after I finished the modification I noticed my ikelite cap on the coil side was broken off at the threads...so rather than take it all back apart I just used some that plumbers helper epoxy putty around the cable penetration on the ikelite cap... if you decide to tackle doing your own repairs do a lot of research 1st... while it’s not terribly hard it ain’t exactly easy either....


SubjectAuthorViewsPosted

Question before sending in my Excalibur 1000

DigDugNY211June 10, 2019 09:56AM

Re: Question before sending in my Excalibur 1000

bootyhoundpa86June 10, 2019 05:11PM

Re: Question before sending in my Excalibur 1000

Rick(ND)105June 10, 2019 12:23PM



Sorry, only registered users may post in this forum.

Click here to login