Findmall.com
 
 






Modifications Forum


Welcome! Log In Register
excallibur coils comparison
Posted by: mike k.
Date: August 19, 2018 09:53AM
pros and cons required for Cors Scout 12.5" x 8.5 " coil compared to NEL Hunter 12.5" x 8.5" . Also are the connectors , for these coil cables , as seen on @#$%& , from Ukraine suitable ? - thanks

avatar
Good question. I'm also interested about suitability of Ukrainian coils for the Excal.N/T
Posted by: Greg (E.Tn)
Date: August 20, 2018 11:24PM

(This message does not contain any text.)


avatar
Re: excallibur coils comparison
Posted by: bootyhoundpa
Date: August 29, 2018 05:49PM
I have the nel thunder coil,10in.tornado coil and 14in wot coil.. i did the ip68 connector mod to each to make them interchangeable between the excal and sov gt.. so far so good but i dont have alot time or saltwater time on them....after i soldered both ends and verified they work i filled the terminal cavity with clear silicone rubber as a 2nd line of defense if compression fitting fails... i am happy with the quality of the Ukrainian ip68 connectors but man it took a long long time to arrive... i think it was over a month both times i ordered them...

avatar
Re: excallibur coils comparison
Posted by: bootyhoundpa
Date: August 29, 2018 08:27PM
I might also say it's very important to keep sand out of the male and female fine plastic threads on the ip68 connector..

Sorry, only registered users may post in this forum.

Click here to login