Find's Treasure Forums
Welcome to Find's Treasure Forums, Guests!
You are viewing this forums as a guest which limits you to read only status.
Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.
Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.
Click here to register!
Need Support Help?
Cannot log in?, click here to have new password emailed to you
ATX stock coil floppy
- Thread starter JCR
- Start date
WaterWalker
Well-known member
I have not heard of anyone taking the shaft/coil joint apart without cutting the post on the coil.
Call Garrett. Your two year warranty can't be up yet.
If I am correct in the assembly procedure of the shaft/coil, the post with the adjusting screw in it is heated and bent down over the pin that the coil rotates on and then the adjustment screw is put in place and tightened.
There is a Coil Support Bracket available on an auction site and there are discussions in the forum about the bracket.
Call Garrett. Your two year warranty can't be up yet.
If I am correct in the assembly procedure of the shaft/coil, the post with the adjusting screw in it is heated and bent down over the pin that the coil rotates on and then the adjustment screw is put in place and tightened.
There is a Coil Support Bracket available on an auction site and there are discussions in the forum about the bracket.