Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.

dan, i gought a new yellow one today

I used Gorilla glue on mine and haven't had any problems. I did switch to the 10" coil today for our seeded hunt so I used the plastic rivets Minelab uses as a precaution.
 
It expands to fill any voids so be prepared to grind (yes you will have to grind it) the excess off after curing. It worked out perfectly for me because my fishing pole shaft was slightly tapered and the glue filled it in nicely.

I also cut a section of the pole and ground the mating surface to fit over the full shaft leaving the sides with flaps that extend past the center point of the shaft. These flaps, along with some glass mat and epoxy mounted the handle very firmly.
I guess I will have to break down and take some additional photos but not today. Club seeded hunt today.
I also came up with a very neat method of mounting the meter to the hand grip. I will get some photos of this too.
Dan
 
You must log in or register to reply here.
Top