Does the Vibra probe have alot of crosstalk with the t2?

[Jay Evans]

Or do I need to go with the garrets pro pointer?
any thoughts on this?
Thanks in advance....

 

[Monte]

make or model detector. With some it is there but not heard, and with others you might hear a little raspy or chattery noise. It might be eliminated or reduced it you position the search coil and/or control housing a little farther from the pinpointer.

Personally, I use a Garrett Pro Pointer most of the time because that is what I had when I switched over to Teknetics detectors. Better depth and general performance than I saw from a Vibra Probe as well as lighter and handier. For me, I usually pinpoint just fine with the detector so my use of a pinpointer is seldom, and when I do it is brief so there's little need for concern about interference, and I am using ALL of the Teknetics models.

Monte

 

[Jay Evans]

Thanks for the insight Monte, I have almost made the decision to switch over totally to the Teknetics family. Your helpful posts/ replies are always useful to me and most others on this forum.
Thanks again....

 

[Elton]

I had an older vibraprobe Jay..It really did effect the T2........ constant noise when Vibraprobe was on... Solved the problem with a Garrett Probe..Garrett is deeper too...

 

[Jay Evans]

Thanks Elton... I'll live with it til I can swap for one or buy one.... I have had it talk to detectors in the past, but wasn't sure how it would react with the T2.
Thanks again....

 

[earthmansurfer]

The Garrett Pro Pointer is simply incredible. It saves so much time and saves a few coins too. Another thing I did was by a Lesche knife when I was back in America, another time saver...
Oh, no problems at all with the the Garrett and my Omega or when I had the T2.