Eric Foster, Rev-discrimination

[Anonymous]

Eric,
My PI DIS,works with 555 timer by way of a on/off switch.This will blast you ears lose from your head.
Over a year ago when I was adjusting coil damping
resistor(I have no scope)so I used a 2 way switch between resistor's and coil,until I got what I wonted
for damping resistor.
I also noted that this would make a good Rev-DIS.Its
the ideal way to do it.
Question,-Switching coils damping resistance back
and forth, checking each target.will this damage
circuits in my PI. Thank's
Frank

 

[Anonymous]

Eric,
To save you a reply.
After I asked the question about Reverce-DIS.I went
home and wired up a 2 way switch on damping coil in
my CS-6.it worked but not very good.it will only be
usefull on small nuggets.
Frank.

 

[Anonymous]

Frank: you are optimistic! who said you were going to find any big nuggets LOL....Don

 

[Anonymous]

I live in FL,all-ways think positive.Some time's yellow and silver metal wash on the beach about size
of 1/2 dollar,with spanish writeing.Like to keep beach clean of litter.Be-n doing this over 45yr's.
L-O/L ($).

 

[Anonymous]

You are correct, I just left FL, all those hurricanes I hope has done a job also in turning up a lot of Spanish treasure down around FT Pierce area, if you are near there. HH...Don