Explorer programs??

[M.L. Hinds]

I was wondering if someone or a few someones can send me some pictures of some of the screens and typed out settings they use with success to hunt coins and rings seperate and together?? I understand it may take a little time but would sure app. it. I hunt iron mask wide open and fast and deep response thres. just aud. at 24-26 senc. fixed. just curious what others are doing??

 

[Mike (Virginia Beach)]

I hunt deep on, fast off with a fairly slow sweep. The two don't generally go together. You either want to go fast of your want to go deep. As far as the rest of it, sounds fine. It's about getting to know the tones and the numbers (or the cursor, if you prefer) and I run IM-16 as well.

Check the "Explorer Tips" section on this site:

http://www.detectorgear.com/

 

[Boony]

Hi, Hope this helps, I put the EX SE or EX II in the learn mode, get a sample of all the different coins I pick up, all my gold and silver jewelery that I have picked up in the past, all my Wife's jewelery, I then wipe all my coins over the coil and save the pattern in S1, I then do all the jewelery and save it in S2, I use the large cursor because when some of the items are in the ground they become corroded and can give off a slightly different response to a nice shiny new coin, by doing it this way it gives the Explorer a bit of leeway when getting a signal. I then select S1 and S2 to hunt. For the parks I use a sensitivity setting between 5 and 10 as I am only permitted to search the surface area and can't dig holes. For the beach or old farm sites I run the sensitivity as high as I can maintaining stability.

Hope this is of help to you ...all the best... Boony