Frequency to eliminate inference between HF coil and CTX 3030

[pine3874]

Using my HF Elliptical coil and my hunting buddy using his CTX3030 we haven't been able to find a frequency in my case or a noise cancel channel in his case that will eliminate the interference between the two machines. Anyone out there using a HF coil and hunting with someone using a 3030 been able to get rid of the interference? If so, please let me know the settings. Thanks

 

[MikeLab]

I don't know but I heard with the nox you get near them with your machine running and ask them to do a noise cancel.

 

[pine3874]

I don't know but I heard with the nox you get near them with your machine running and ask them to do a noise cancel.

As I stated in my post, we tried that to no avail.

 

[jmaclen]

CTX 3030 FBS full band spectrum is theoretically simultaneous 1.5 kHz to 100 kHz. Depending on how the CTX is set up cross-talk could be next to impossible to eliminate since your HF elliptical is 13 kHz to 81 kHz.

When I'm at a group hunt with my club most of the Nox and CTX guys (why would you bring a CTX to a shallow planted hunt????) get the bleep away from the Deus folks. We all try to avoid the people with big foot clean sweep rectangular coils!!!!

Jeff

 

[MikeLab]

Did you try to restart your machine when you are next to his? That's when the noise cancel occurs.

 

[pine3874]

When using my Tek Minuetman operating at 7.81 kHz, there is absolutely no inference at all between it and the ctx 3030. Unfortunately the HF coil doesn't go that low. I'm thinking about getting a X35 coil and maybe that will eliminate the interference since I can run it at 7 kHz.

 

[bigtim1973]

Hey further away and keep searching

 

[pine3874]

I enjoy checking targets with my hunting buddy and learning new things from doing so. With the interference it just doesn't make it as enjoyable.

 

[Xdigger]

Using my HF Elliptical coil and my hunting buddy using his CTX3030 we haven't been able to find a frequency in my case or a noise cancel channel in his case that will eliminate the interference between the two machines. Anyone out there using a HF coil and hunting with someone using a 3030 been able to get rid of the interference? If so, please let me know the settings. Thanks

Quit hunting with Minelab users,

 

[martygene]

once you start the deus, out the coil to the ground and have the ctx do a noise cancel. it will find your frequency and change itself to another one. as long as you remain apart about 10 yards or so you'll be good to go.