[size=large]For sale is a beautiful Los Banos CZ-3D that was sent to Tom Dankowski and tuned. This detector looks great and works even better. Now is the time to pick up one of the detectors that are becoming rarer each day. Below is what Tom did to it:[/size]
[size=large]$599 Shipped[/size]
http://www.backwoodsmetaldetectors.com/product/los-banos-fisher-cz-3d/
[size=medium]1) 'Salt' balance very slightly out of cal...... very minor alignment performed.
2) Deep target audio smear non-existent....... no correction needed.
3) I boosted 'Salt' mode auto-tune/all-metal Sens a bit more.
4) I stabilized the electronics to a greater level of stability.
5) 'Salt' nickel ID very slightly out of cal....... and now back in spec's.
6) 'Salt' zinc ID was exacting...... per engineering spec's.
7) Grnd Bal internal set-point was slightly out of cal..... and is now in spec's.
'Enhance' mode nickel ID was very slightly out of spec's...... and is now per engineering design.
9) 'Enhance' mode zinc ID was exacting/per engineering design...... no calibration needed.
10) 'Enhance' auto-tune/all-metal Sens was boosted about 0.2" more.
11 Internal electronics were somewhat dirty...... cleaning performed.
12) Unit was 11.4" on a clad dime in 'Enhance' mode. Unit is now 11.7" on a clad dime in 'Enhance' mode.
13) Front-end circuit board was slightly loose...... and is now tight.
14) Audio boost circuitry exacting ......... per engineering design.
15) I boosted 'Enhance' mode auto-tune sensitivity a bit more.
______________________________________________________________________________________________________[/size]
[size=large]$599 Shipped[/size]
http://www.backwoodsmetaldetectors.com/product/los-banos-fisher-cz-3d/
[size=medium]1) 'Salt' balance very slightly out of cal...... very minor alignment performed.
2) Deep target audio smear non-existent....... no correction needed.
3) I boosted 'Salt' mode auto-tune/all-metal Sens a bit more.
4) I stabilized the electronics to a greater level of stability.
5) 'Salt' nickel ID very slightly out of cal....... and now back in spec's.
6) 'Salt' zinc ID was exacting...... per engineering spec's.
7) Grnd Bal internal set-point was slightly out of cal..... and is now in spec's.
'Enhance' mode nickel ID was very slightly out of spec's...... and is now per engineering design.9) 'Enhance' mode zinc ID was exacting/per engineering design...... no calibration needed.
10) 'Enhance' auto-tune/all-metal Sens was boosted about 0.2" more.
11 Internal electronics were somewhat dirty...... cleaning performed.
12) Unit was 11.4" on a clad dime in 'Enhance' mode. Unit is now 11.7" on a clad dime in 'Enhance' mode.
13) Front-end circuit board was slightly loose...... and is now tight.
14) Audio boost circuitry exacting ......... per engineering design.
15) I boosted 'Enhance' mode auto-tune sensitivity a bit more.
______________________________________________________________________________________________________[/size]