[size=medium]1021 Los Banos Fisher CZ-3D with 8" and 10.5" Coil. This detector will hit a clad dime at 11.4". It is in great shape and I will put up pictures tomorrow.
$689 Shipped. Richard
This the report from Tom Dankowski on the CZ3D.
________________________________________________________________________________________________________________
1) 'Salt' balance very slightly out of cal...... very minor alignment performed.
2) Deep target audio smear non-existent....... no correction needed.
3) I boosted 'Salt' mode auto-tune/all-metal Sens a bit more.
4) I stabilized the electronics to a greater level of stability.
5) 'Salt' nickel ID very slightly out of cal....... and now back in spec's.
6) 'Salt' zinc ID was exacting...... per engineering spec's.
7) Grnd Bal internal set-point was slightly out of cal..... and is now in spec's.
'Enhance' mode nickel ID was very slightly out of spec's...... and is now per engineering design.
9) 'Enhance' mode zinc ID was exacting/per engineering design...... no calibration needed.
10) 'Enhance' auto-tune/all-metal Sens was boosted about 0.2" more.
11 Internal electronics were somewhat dirty...... cleaning performed.
12) Unit was 11.4" on a clad dime in 'Enhance' mode. Unit is now 11.7" on a clad dime in 'Enhance' mode.
13) Front-end circuit board was slightly loose...... and is now tight.
14) Audio boost circuitry exacting ......... per engineering design.
15) I boosted 'Enhance' mode auto-tune sensitivity a bit more.[/size]
$689 Shipped. Richard
This the report from Tom Dankowski on the CZ3D.
________________________________________________________________________________________________________________
1) 'Salt' balance very slightly out of cal...... very minor alignment performed.
2) Deep target audio smear non-existent....... no correction needed.
3) I boosted 'Salt' mode auto-tune/all-metal Sens a bit more.
4) I stabilized the electronics to a greater level of stability.
5) 'Salt' nickel ID very slightly out of cal....... and now back in spec's.
6) 'Salt' zinc ID was exacting...... per engineering spec's.
7) Grnd Bal internal set-point was slightly out of cal..... and is now in spec's.
'Enhance' mode nickel ID was very slightly out of spec's...... and is now per engineering design.9) 'Enhance' mode zinc ID was exacting/per engineering design...... no calibration needed.
10) 'Enhance' auto-tune/all-metal Sens was boosted about 0.2" more.
11 Internal electronics were somewhat dirty...... cleaning performed.
12) Unit was 11.4" on a clad dime in 'Enhance' mode. Unit is now 11.7" on a clad dime in 'Enhance' mode.
13) Front-end circuit board was slightly loose...... and is now tight.
14) Audio boost circuitry exacting ......... per engineering design.
15) I boosted 'Enhance' mode auto-tune sensitivity a bit more.[/size]