Keith Southern
Active member
Wasn't planning on getting another one but managed to get my original back after it was serviced .....
Well it does hit high conductor's now ......Still think more than ground balance was involved ...It's not mind blowing on high conductor's but it is acceptable....But the real power is in the lower conductor's say 70 on down...man you got to see the sensitivity to believe it ...And it's super stable at 100 gain....
O'K' I hot a spot in the woods I have been hunting for a couple of weeks with the T-2....it's a small house site and was sure I had it cleaned out on the easy targets ...especcially since I was running the t-2 extra hot 99 sens..
Well I was wrong I didn't spend a lot of time in there today but I got some easy target's the t-2 just plain missed and I was using the T-2 in 1 tone disc 21...I used the GB disc 30 2 tone..And pulled some targets ...couple of toe taps, part of a pewter spoon ,lead pencil,Keyhole for trunk,stud piece.suspender clip lantern part was real deep about 11 inches...ground was 85 4 Fe bars..
couple of the targets came out of holes I had started with the T-2 then stopped thinking they were iron
Great machine for low to mid conductors in bad dirt...I'll bet coin's on edge will hit good too.First pic is shot of chimney.. second is find's
Keith
Well it does hit high conductor's now ......Still think more than ground balance was involved ...It's not mind blowing on high conductor's but it is acceptable....But the real power is in the lower conductor's say 70 on down...man you got to see the sensitivity to believe it ...And it's super stable at 100 gain....
O'K' I hot a spot in the woods I have been hunting for a couple of weeks with the T-2....it's a small house site and was sure I had it cleaned out on the easy targets ...especcially since I was running the t-2 extra hot 99 sens..
Well I was wrong I didn't spend a lot of time in there today but I got some easy target's the t-2 just plain missed and I was using the T-2 in 1 tone disc 21...I used the GB disc 30 2 tone..And pulled some targets ...couple of toe taps, part of a pewter spoon ,lead pencil,Keyhole for trunk,stud piece.suspender clip lantern part was real deep about 11 inches...ground was 85 4 Fe bars..
couple of the targets came out of holes I had started with the T-2 then stopped thinking they were iron
Great machine for low to mid conductors in bad dirt...I'll bet coin's on edge will hit good too.First pic is shot of chimney.. second is find's
Keith
questions! How did the disc 30 tone break work out for you in iron? I know it would depend on the site but did quite a bit of iron come in with the high tone and where is the small nail break point... equivalent to 16 on the Omega and 21 on the T2? Were good targets found below 40 when co-located or did it squeak em all out as non-ferrous?