MI 6 and Deus 2 RC connectivity and programming issue ??

[BobM (Oregon)]

Hey all and Happy Holidays,
Im wondering if any of you have also run into this and have had the same issue and if so, found a fix ????
I have my MI 6 paired and programmed to hear the pinpointer through the headphones on my D2.
Whenever I add a new program, the pinpointer remains paired BUT, you can’t hear it through the headphones and
the pinpointing screen on the remote doesn’t come up when you want to pinpoint something in the hole……
Only after unpairing and then re-pairing the pinpointer to the RC does it work again on all the programs.
Any ideas ?
I haven’t encountered this using the Deus 1 I’ve been swinging the last 7+ years
Additionally, after getting the D2 and pinpointer re-paired to each other and functioning normally, it will connect most of the time.
There are however times I can‘t get it to connect to the remote after trying 2 or 3 times and then it will finally connect.
Thoughts, opinions and comment’s always welcome.
Best,
Bob

 

[BobM (Oregon)]

I should have mentioned that I’m using version 1.1
In addition to not hearing any pinpointer sound through the headphone after turning it on to pinpoint, there isn’t any coil chatter/noise in the headphones either ….
it only works after re-pairing the pinpointer again and then functions normally on all programs including the added ones.
Thanks again for any thoughts or comments,
Bob