Lorrie1 said:
I am learning to use the XP Deus. I was out the other day and the Deus picked up a target but when I put it in pinpoint mode the pinpointer did not sound off. If I pressed my coil to the ground I could get a signal sometimes. When I dug, I could not find anything. This happened to me several times. Sometimes my pinpointer would sound off but I could find nothing in the hole. Any suggestions would help.
Thanks,
Some pointers and info.
Like it's been said,,,engage while over clean ground,,,if you try to do over target,,,detector will not be tuned properly,,hence you may not hear target.
Also,,try to X your target when sweeping,,,sometimes if in and around iron and nails,,this may be hard(ear) to do.
Use this location to dig.
On deeper targets,,as you take off dirt,,,target may disappear especially when sweeping in hunt mode (disc mode).
If you get confused,,try to resweep target hole,,from different angles,,you might tilt your coil,slightly,,doing this,,may reflect which side of hole target my be in and dig accordingly to find.
Usually when retrieving a target,,,a good sign to see,,,,is when the target disappears after digging,,,,this I feel is best thing to happen,,,shows you are probably on the right trail.. Be persistent,,,,I know this may sound hard,,,but when you get more confidence with your detector,,,you will find,,,it most times is not lying to you--- hence find your find.
Can be tricky at times,,,and more time consuming than other times. I guarantee some folks have give up and left good finds in the ground.
Good luck