Now my Headhunter Pi Project can operate with either the 11" DD GQ SS coil Reg made or both the 8" and 11" inch mono coils Eric made

[Anonymous]

Thank you Mr. Bill, Eric, Terry Crenshaw, Reg and Scott for the past support. Without you, I never would have completed and achieved my project.
Today, Mr. Bill gave me a quick run down on modifying my Headhunter Pi project to accept a DD coil, Because of the Modified GQ SS I bought from Scott which includes the DD modification helped me understand how the DD and the Mono coil can work together.
Using the same male/female connectors of the GQ SS coils and with Mr. Bills quick run down, I was able to put together the same set-up with the Headhunter Pi circuit board to operate with the same three coil set-up for the GQ SS.
Pictured above is my Headhunter pi project detector/probe just finishing air testing all three coils "11" DD coil, the 8" and 11" mono coils" All three coils air tested well with the unit working through the entire delay and the threshold holding a steady hum.
Now that I know the unit operates well, I'll put everything back into the small hip mounted housing. This little hip mounted detector went through a lot this week, From a detector, then to a detector and probe and now the unit's sports both a DD and mono coil.
Thanks again,
HH, Paul (Ca)

 

[Anonymous]

<img src="/metal/html/wink.gif" border=0 width=15 height=15 alt="">

 

[Anonymous]

Hi Chuck,
Thank you for the nice comment, But honestly, I'm not even near the caliber of the others on this forum. Most even view me as crazy, In all honestly I enjoy trying which I will take credit for <img src="/metal/html/smile.gif" border=0 width=15 height=15 alt="">.
Thanks again,
HH, Paul (Ca)

 

[Anonymous]

you are having fun and gettin' the job done too! From what i've read, you sound pretty innovative to me! <img src="/metal/html/biggrin.gif" border=0 width=15 height=15 alt="">