T2 looking through the trash

[Bartman]

Any tips on what settings you like to use for heavy trash areas? I have an old house where the porch has collapsed and there is a ton of iron, aluminum, but I'm pretty sure there is some older coins in the mix. I'm thinking of one of two tactics.

Disc: 74
Tones: 1+

Dig everything that beeps. My only concern is discriminating the beeps from the deep iron vs. the coins.

Disc. 41
Tones: 2+

Dig all the high tone repeatably signals. Same concern with the iron as above.

I usually know when I have deep rusted iron (jumpy signal, high numbers, but ferrous bars increase), however I don't want to miss the small seated dime that is next to that stuff.

I have the sniper coil as well, just a little conerned about depth as this is an old site.
Any tips, beside the obvious dig everything?

 

[ez4sure]

if you have the 5 inch coil i would use it and run 4 tones if you hunting for silver, i also like 1+ tones disc at 21 and dig everthing sounds good and that pinpointes good you should get a few goodies there good luck