Tesoro Bandido

[GazinUK]

Have this coming in a few days, as can be seen the shaft mount has been snapped off. Are these moulded into the case or do they slide/clip into place? Thanks.

 

[wishfish]

I don't have a bandido, but on my sand shark, which uses a similar style case, it is molded on. You'll have to do some plastic welding or sand it off, I think.

 

[GazinUK]

I don't have a bandido, but on my sand shark, which uses a similar style case, it is molded on. You'll have to do some plastic welding or sand it off, I think.

Thanks, I thought that might be the case.

 

[vito]

It looks like it's two parts. But the shaft mount seems to be glued in. Just push'n'slide doesn't work on mine.
If I had to remove the stem holding part I'd use some isopropanol alcohol on the seam. If that doesn't work, I'd put it into the oven at 80°C/175°F leaving the ovens door OPEN and check the connection from time to time.
But before doing anything I'd remove the electronics. This can be done by removing the two srews which hold the beltplate in position.
regards

 

[vito]

Have this coming in a few days, as can be seen the shaft mount has been snapped off. Are these moulded into the case or do they slide/clip into place? Thanks.

Hello @GazinUK . It would be nice to know what the switch on its back is for. "fixed" -?? - GB? Threshold?
Can you tell when it arrived, plz.

 

[GazinUK]