What are the three factory pre-set programs when MI-6 is paired to detector?

[pine3874]

On page 12 of the ORX manual it says:

"Choose from one of the 3 factory pre-set programs in the menu to make your own custom program which can then be saved as (prg4)"

Does anyone know what these three pre-set programs on the paired MI-6 are? I can't seem to find the answer anywhere. Thanks

 

[MikeLab]

Press the "+" or "-" button on the remote control to scroll through the programs. #1 has sensitivity at "7", #2 at "30", #3 at "45". The other parameters do not change unless you do so manually. You can save the changes to program "4" if you want.

 

[pine3874]

Press the "+" or "-" button on the remote control to scroll through the programs. #1 has sensitivity at "7", #2 at "30", #3 at "45". The other parameters do not change unless you do so manually. You can save the changes to program "4" if you want.

How does one activate or deactivate the led light from the remote?

 

[John (Australia)]

In regard to turning off the LED look about half way down under Advanced http://www.xpmetaldetectors.com/telechargement/Instruction_manual/MANUEL%20MI-6%2011.10.17.pdf

 

[pine3874]

I know about turning the LED on and off from the pinpointer. My question is: Is there a way to turn the LED on and off from the remote in program 7?

 

[James/Washington]

You can only turn the light on or off through the MI-6.

 

[pine3874]

You can only turn the light on or off through the MI-6.

Ok, thanks. That's what I thought, but just wanted to make sure I didn't miss something.

 

[MikeLab]

Light has little effect on battery level. Vibrator is the one that draws a lot of power. But that battery has more than enough power for all of it.