Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!



Need Support Help?

Cannot log in?, click here to have new password emailed to you

ACE 250 Compendium STARTS NOW!

DavHut

New member
[size=medium]Just about everything you'll need to know about the little ACE 250, is in my unofficial ACE 250 Compendium - gathered from all over the posting boards... well, mostly from here. :thumbup:

I figured it could do the most good for the most people HERE on the forum. With that said, I'm going to post it again for those who missed it in the past. It will go on over the next few weeks as a serial, so check back often for updates.

Ready? Here we go - copy, click and paste, baby!

INSTALLMENT ONE

Ace 250 tips, from THE One and Only Bill Revis:

"Somewhere on this forum I spoke of it when I field tested it way back. It's very sensitive so run your sensitivity at four bars to start with. Target response and recovery is lightning fast so it's virtually impossible too swing to fast to miss targets. This makes the Ace 250 a great candidate for competition hunting.

Also, if you whip the coil it will go somewhat deeper. Careful scanning still works best, though."

(DAVID - And that is one of the great things about the Ace 250 - it will allow both tactics.
Let me add here that my testing supports what Bill said on fast swing speeds. In fact, deep targets are often picked up more reliably by fast scanning than with slow swings.
On my wedding band, which is 14K and thus just above nickels in conductivity - that is to say, a relatively weak conductor - the only way to pick it up at anything over 5
 
You'll have to make a change bud. Twitching is a procedure to ID coins that won't ID, due to being on edge, heavily corroded, etc. If you get a broken or one-way signal twitching will often turn it into a good signal. The Minelab boys call it wiggling.

If you get such a signal, center the coil over it and whip the coil back and forth a couple of inches each way rapidly ( hence the term, "Twitching." Remember, this is a motion detector and faster motion equals better descrimination and depth.

Bill
 
n/t
 
Top