AT Pro Sensitivity Settings and Target IDs

[jlopez5555]

Guys, I've seen the target ID lists floating around but those, I believe, are with users running their machines at near full sensitivity. I have been hunting with my AT Pro at only 3 bars of sensitivity. It seems to be much more stable but I am looking for a target ID listing at that sensitivity level. Does anyone know where I can find something like that? TIA.

 

[MikeLab]

ID numbers should be the same. If the target is deep and on the edge of detection the numbers are not going to be accurate.

 

[grumpysrb]

I have seen the lists, and the numbers don't always match what I get. It's best to make your own list and use others only as a reference/starting point.

 

[MikeLab]

Remember the ID numbers are most accurate when you sweep the coil directly over the target and keep the coil at the same level. At high sensitivity, surface targets are all over the place so you could try to lift the coil up a few inches and see if that helps.