Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

coil cover

A

Anonymous

Guest
Any suggestions on putting the coil cover on a CZ 10.5" coil
 
This is what I do and it works for me. I take a knife and a file and clean any rough places inside the coil cover and on the coil, some times they leave some epoxy sticking out. HH..BJ
 
By reading some past posts, once you get the cover on the coil you might want to seal it with some silicone to keep sand, etc. from getting between the coil and the cover. For this can give some falsing. From what I have read it is very difficult to remove the cover, sometimes the only way is to break it off.
Good luck.
 
Some coil cover runs fit awful tight. If I read your post correctly thats your problem..Simply put the coil cover in real hot water and it will expand allowing you to fit it on the coil..
 
You must log in or register to reply here.
Top