Find's Treasure Forums
Welcome to Find's Treasure Forums, Guests!
You are viewing this forums as a guest which limits you to read only status.
Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.
Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.
Click here to register!
Need Support Help?
Cannot log in?, click here to have new password emailed to you
D2 audio settings.
- Thread starter Dan(NM)
- Start date
There is likely no one setting(s).
Why?
Size of target, size of coil are drivers. Even frequency used per conductivity/ size of target.
Audio response setting (depending on setting) will drive behavior.
Plus volume adjustment.
Single freq can loads of times give lower volume signal strength vs Mulit freq use over same scenario.
Ground mineralization levels could play into this as well.
Do your own test and do some checks in the wild varying settings over located target and carefully dig to see the depth of target.
Why?
Size of target, size of coil are drivers. Even frequency used per conductivity/ size of target.
Audio response setting (depending on setting) will drive behavior.
Plus volume adjustment.
Single freq can loads of times give lower volume signal strength vs Mulit freq use over same scenario.
Ground mineralization levels could play into this as well.
Do your own test and do some checks in the wild varying settings over located target and carefully dig to see the depth of target.