Euro Shark

[RickG]

Just having some fun with a Tesoro EuroSabre I had laying around. I machined the housing, covers, and pot extensions at home. I'll probably end up changing things by the time I'm done-it's getting a little bulky! I have a MXT for land use.

First time posting here-hope it works...

 

[Beachcomber]

n/t

 

[GraveDiggerMax-VaBch-Va]

did u seal up the bottom the same way and how did u get the coil wire in?

max

 

[RickG]

Yes, the bottom is a similar plexiglas plate fitted with an O ring. I haven't installed the coil connector yet. I was either going to use a waterproof Deutch bulkhead connector or just install the cable through a plastic, weatherproof strain relief.

The first housing was a square PVC electrical box but the seal was less than desireable with only screws at the 4 corners. I may change my approach on the pot extensions so I can shorten them up a bit but I'll try this first. I'm hoping I don't need to add a case vent so I can put it together or get it apart!

Thanks for looking....