hargrovebrian
New member
Hello
I would like to build a 1.8 meter square coil for my minelab F1A4 pulse induction detector.
I have been told that this is a dumped down SD2200?
I have purcashed coil wire for the SD detector will this work?
I have not taken any readings from my present coil but will as long as i end up with the same or close to same readings will i be OK?
I have a 2 pin coil connector should i use a coax lead to the coil or can i just loop the coil ends from pin to pin?
I am looking for a 232data logger 6 volt lead acid battery that minelab sells (used) (cheap)
THANK YOU
Brian
I would like to build a 1.8 meter square coil for my minelab F1A4 pulse induction detector.
I have been told that this is a dumped down SD2200?
I have purcashed coil wire for the SD detector will this work?
I have not taken any readings from my present coil but will as long as i end up with the same or close to same readings will i be OK?
I have a 2 pin coil connector should i use a coax lead to the coil or can i just loop the coil ends from pin to pin?
I am looking for a 232data logger 6 volt lead acid battery that minelab sells (used) (cheap)
THANK YOU
Brian