I just got my T2 yesterday and today I braved the cold (32 dgrees) and took it out for a test spin. First, I read the manual last night at work and I had a pretty good idea on how I wanted to set it up. I am a coin hunter and most all of the advice I have recieved has been for relic hunting. Anyway, I ran the disc mode, sens at 75,disc at 10, and three tones. It was real chattery and I was unimpressed. Then, I forgot that I didn't ground balance. I fast grabbed it and it settled down, but I didn't care for the three tones. Way too much tone jumping. I decided to switch to Paul's (Old California) two tone setup that he uses for relic hunting. I ignored the low tone and checked any of the high signals. This field is loaded with pulltabs and I dug three or four mid 70's vdis to confirm what they were. They were all pulltabs. I got a solid nickle lock on and it stayed nickle from every angle. Low and behold, from 7 to 8 inches, I got a crusty Liberty head nickle. I got a few more nickles and two wheat pennies from the same depth. I initially did not like the pinpointing, but I came up with a fool proof method and from that point on, I never dug a plug bigger than 3 inches by 3 inches. I have found seated silver coins from this field, but no silver today. I was afraid that the T2 would not be a good coin hunter, but today answered that concern. So far as not saving the last setting, this detector can be set up in twenty seconds or less and the menu is the easiest I have ever used and I have owned every detector made. I have not got the T2 into really heavy trash and I doubt that it will shine there, but for moderate trash sites, it will serve me just fine. Also, it is without a doubt, the best balanced detector I have ever used, except for the Tesoro Umaxes. I am very impressed, but my hunting season is almost done with the coming of winter, so it might be next spring before I can truely test this detector out. R.L.