Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

Modifications

A

Anonymous

Guest
Mr.Bill, Do you make sensitivity modifications for the Sandshark? Maybe nothing can be done because it is just 600pps. "NT"
 
There's not much you can do to the Sandshark because the timing is all PIC controlled. About all you can do is adjust the damping, but I suspect that with PCB coils it's pretty optimal and well-controlled.
What I want to do is try a standard coil, I suspect that the printed coil is limiting performance. The SMPI front-end is almost identical, so I would like to give that coil a try. However, I need the connector Tesoro uses for the SS, and so far I have not been able to determine where to get them.
- Carl
 
Carl,
On their first PI, the Piranha, it used the same coils. That used a Surfmaster PI circuit that was modified a bit. I remember using a Surfmaster PI coil, and changing out the damping resistor.
If I remember correctly there was a problem with the coils with it
 
<I>I have never run across the connector on the outside. Perhaps a phone call to them, and they may give one up ?? </I>
I tried asking one of the Giffords, no reply... perhaps I should try again.
 
You must log in or register to reply here.
Top