Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

Need help

A

Anonymous

Guest
When i go in to edit my paattern and reject parts of the screen some of the area dont turn black and doesent matter what size target frame i use. even that i rejected this area will i still get a singal from it. It's not much white and its a the bottom of the screen and about as big as the small target frame and about a 1/4 inch long.
 
Set the cursor to small then move it to the bottom of the screen. Then change it to the mid size cursor and select reject "X" and as you move it right or left it will wipe out that bottom line you couldn't get.
 
Wally I tryed that but it didnt remove it. It's right at the bottom of the screen. what iam saying is that if you put the cursor at the bottom of the screen where it wont go down any more thats where the line is that wont darken in.dont matter what cursor you use. If it wont effect any thing i am not going to worry about it. i guess i will have to see if i get a hit in that area and if i do i guess i will have to send it and get it fixed. Thanks for your help
 
what slot your putting it in S1 through S6?.. a few of us were having problems with patterns saved in S6
 
Same here!! I get that little white patch too!!
I turn it off then start again.
 
Jim I use slot 3. Do you know if it will effect me when useing it in the field. If it dont i am not going to worry aabout it. Havent tryed it yet so i dont know if i will get any hits off it. but i will find out i guess.
 
Does that get rid of it because i saved this pattern.and would hate to have to do it again but if have to i guess i will.
 
Any way you can poist a pic of your pattern showing where you cant reject it? try saving it in another slot to have for back up in case you mess up the other.. you can also try resetting the Ezp by holding the power on button for 5 senconds.. it will put you back in factory presets but I dont think you will lose your patterns
 
Do exactly as I said in my first post and it will remove it. Move the cursur to the bottom in the small size first then without moving it up change to medium size. Now you can block out all the way across the bottom so long as you don't move up off the bottom.
 
When passing a target across the coil in my house(clear of interference)i am subject to a different cursor reading a lot of times.I was advised to set sens. to 1 and thres.low but i still get the shotgun effect.?????????
 
You must log in or register to reply here.
Top