Trailduster
Active member
Hi All.
Just got my f70 in the mail today, grabbed a hand full of coins and ran outside to test her out. Coins were Walker Half, Barber dime, Clad Quarter, & 1800's large cent.
Ground balanced to instructions with a double digit VDI of 90. Is this a normal GB number?
Played with the sens, discrim, and all that. My NY soil runs real quiet can pretty much run as high as I want all around. So I went Sens 90, Thresh 0, Disc 20 as well as Disc in the quarter dime area. Dp and 3H tones.
Unfortunately my yard is well hunted out with the f2 I had, but I was able to get some blips here and there with low disc although the screen showed low confidence.
Here is the kicker. With the coins laying top soil, the Walker came in as a 21 as did the clad quarter and large cent. The Barber dime was 16. none would show up unless I was 4" or less over them sometimes the dime not at all. I was expecting WAY higher VDI numbers especially being silver.
The in ground junk also showed what should be realistic pin point depth numbers.
DD coil used don't have the concentric.
What's up with the depth and low VDI on those top soil coins?
Just got my f70 in the mail today, grabbed a hand full of coins and ran outside to test her out. Coins were Walker Half, Barber dime, Clad Quarter, & 1800's large cent.
Ground balanced to instructions with a double digit VDI of 90. Is this a normal GB number?
Played with the sens, discrim, and all that. My NY soil runs real quiet can pretty much run as high as I want all around. So I went Sens 90, Thresh 0, Disc 20 as well as Disc in the quarter dime area. Dp and 3H tones.
Unfortunately my yard is well hunted out with the f2 I had, but I was able to get some blips here and there with low disc although the screen showed low confidence.
Here is the kicker. With the coins laying top soil, the Walker came in as a 21 as did the clad quarter and large cent. The Barber dime was 16. none would show up unless I was 4" or less over them sometimes the dime not at all. I was expecting WAY higher VDI numbers especially being silver.
The in ground junk also showed what should be realistic pin point depth numbers.
DD coil used don't have the concentric.
What's up with the depth and low VDI on those top soil coins?