outlaw no motion question

[pax]

when hunting in no motion and hit target when do i need to press the retune button?

 

[mike5853]

Hi pax - when you locate a target in the NMAL mode, center the coil over the target then move it off center, just a inch or so, then raise the coil about an inch, press Retune and you'll find the target footprint is reduced. You can repeat to significantly shrink the target footprint but for coins once should be enough. Keep in mind you will loose a little depth when you do this, so rtemember to raise the coil. Hope this helps.

 

[pax]

thanx for the help mike , also does disc effect NMAM?

 

[GunnarMN]

pax if you are in the NMAM and move the disc counter clockwise it will cause it to sound off if you move the disc dial clockwise it will lower its sensitivity, I set the disc whear i want it and then can switch back and forth , I find I have to ground balance with the disc set where i will use it but if you are in disc you can move it but make sure its back to whear you ground balanced at 1st or it may sound off or detune it .

 

[pax]

thanx for your help gunnar