T2 G.B malfunction

[cedarswamp]

The ground balance on my T2 went haywire goes into constant raise coil over load even when the coil is raised hope costumer service is good to deal with has to be sent in asap,,,,,,,,its about four years old and am first owner but cant find warrenty,CEDAR

 

[dougj7]

Have you tried swapping coils.. that is if you have a different one.

 

[Mega]

Have you taken the coil cover off and cleaned the bottom of the coil as sometimes you can get some dirt on the coil and that could cause problems,only a suggestion its worth a try.

 

[cedarswamp]

I separated the coil same results

 

[LaRelic]

Anyone know if there's a factory reset for the T2? Had similar problem with another detector and it fixed the problem.

 

[all iron]

I had to send my T2 back because of a constant overload signal with or without coil plugged in.
took about 10 days from my door to theirs and back.

diagnosis was, the coil cable was defective. not sure how that was when it overloaded with or without coil plugged in but it works great now but i still get an overload signal if machine is on and coil is not plugged in.

 

[pasttom]

Doctor it hurts when I do this... so don't so it.
The obvious answer is... that is what happens when you turn it on without a coil connected.

 

[whitewill_1]

Doctor it hurts when I do this... so don't so it.
The obvious answer is... that is what happens when you turn it on without a coil connected.

Makes sense to me Doc.