Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.

DeepTech

troy X2

L

larox

New member
I could sure use a little guidance on adjusting the ground balance trimmer pot.I am using a 9" coil and it's far to positive .If I remove the face plate where will I find the trimmer pot to make the adjustment? Any help would be greatly appreciated ! Thanks every one. larox
 
Carefull with the wires of course. If you have a "hot rock" that makes it a lot easier but you will end up slightly positive-depending on your ground.

Thats why I went to an external trim adjustor.That way I can use the thresh hold sound in pinpoint for the adjustment. Thats gonna be tough using the internal adjustor.

But remove the faceplate just enough to get a small phillips in there.Mark the pot with a fine tip sharpie before starting so you won't get too far off the factory setting. Then assemble & re-test.
 
You must log in or register to reply here.
Top