XP2 High frequence coil

[Waterdog]

I would like to hear what you all say about the newer high frequency coil with the 3.1 update. When you go over a coin is it stable, what kind of vdi numbers do you get ?

 

[BigTony]

IMO, it enhances the sounds of small bits of metal when dirt fishing. I only used it for a few hours on privates and woods.
It’s stable I guess over coins. I did find two wheat cents and some clad that day.
I still need to get on a beach and see how it does there. I didn’t test its separation ability with coins and bottle caps or nails.

 

[targets]

They dont seem easy to aquire ,thin on the ground for buyers

 

[Foiled]

I'm still using 3.04 with mine, did great at the beach, found a silver necklace, a couple rings, some change and close to 60 tent pegs. It was very silent on wet sand. Coin IDs were kinda all over the place. I dug everything to get to know it.

 

[BigTony]

I'm still using 3.04 with mine, did great at the beach, found a silver necklace, a couple rings, some change and close to 60 tent pegs. It was very silent on wet sand. Coin IDs were kinda all over the place. I dug everything to get to know it.

I’ll probably do the same until I understand what it telling me

 

[D&P-OR]

I'm still using 3.04 with mine, did great at the beach, found a silver necklace, a couple rings, some change and close to 60 tent pegs. It was very silent on wet sand. Coin IDs were kinda all over the place. I dug everything to get to know it.

Need some stability/much more accurate TIDs on that thing.-----I sure hope they get that ironed out!

 

[jmaclen]

Using the HF2 coil with V3.1 software, as long as I keep the Max Frequency on 29 kHz, target IDs are really good using all of the factory search modes. Max Frequency 53 kHz, they start to up average fast with everything reading 3 to 5 target IDs higher. 89 kHz......I just use that for dig it all situations with Pitch 2.

XP made the decision for now to not normalize target IDs at 18 to 20 kHz like they did with the original Deus 2 FMF coils. So the higher the frequency with the HF2 coil, the more target IDs are going to go up. Same as Deus 1 and the HF coils. Those coils did not have ID normalization with Deus 1. They did have ID normalization with the ORX.