Jim upstate NY
New member
figured a reset by holding the power on button would be the best to compare with..
Using a quarter and outside away from interference.. detector on a pair of logs to get it off the ground, a table would do but I dont have one outside.. quarter waved in front of pro coil
as reset by machine.. auto sens.. which was reading 16
about 6 inches before I lost tone in auto
switched to manual which was factory set to 22 from reset
I could get quarter out to about a foot
so I seem to do pretty good in air tests as compared to others, but not sure what your settings were
I can pick up the quarter at man sens 24 out to about 14-15 inches with the SE
I know that is 2 sens levels higher than etrac, but etrac tops out at 30 where the explorer tops out at 32
so should be a close percentage of top powerwise
Using a quarter and outside away from interference.. detector on a pair of logs to get it off the ground, a table would do but I dont have one outside.. quarter waved in front of pro coil
as reset by machine.. auto sens.. which was reading 16
about 6 inches before I lost tone in auto
switched to manual which was factory set to 22 from reset
I could get quarter out to about a foot
so I seem to do pretty good in air tests as compared to others, but not sure what your settings were
I can pick up the quarter at man sens 24 out to about 14-15 inches with the SE
I know that is 2 sens levels higher than etrac, but etrac tops out at 30 where the explorer tops out at 32
so should be a close percentage of top powerwise