i need some program suggestions for the best separation I can get

[beepsilver]

How did this site turn out for you? One thing I'd add to the other recommendations...since you'll be digging near the surface at first, drop your TX to 1 until you need to go a little deeper.

unfortunately I bought a new drag car that wasn't race ready as advertised and that had consumed all of my spare time getting it ready so I wasnt able to get there again before the weeds grew up, I will definitely give tx 1 a shot when I get there this fall,hopefully nobody else beats me to it! Thanks for the suggestion! Rich

No problem, just tell me exactly where it's at and I can scout it out for you

 

[canman678]

I found a sneaky little spot tucked away in a wooded section of a park that had major traffic, there must be a signal every inch literally for about 40 x 250 feet! And there are high tones everywhere and some are definitely old can tops and bigger junk along with the densest tab infestation I have ever found,my Ctx was going nuts partially because I had the 17 inch coil on it so I kicked the leaves aside and was shocked to see several older blackened 1970s clad quarters dimes wheats memorials ect.. and tabs everywhere right on the soil surface, no digging needed! , i said to myself I was going to cherry pick a few high tones and come back with my Deus anyways so I didn't hang around there long.. didn't find any clad later than 1976 it was all just under the surface litter,and I'm almost certain it was never hunted due to the location being abandoned around the early to mid 70s and the trash density being too much for the technology of the era when it would have been possible to hunt it before the undergrowth made it almost impossible to hunt for years until recently, i have been in every major park in my area for years and I have never heard anything like this, depth isn't an issue yet just separation, any help would be greatly appreciated! I really need to read Andys book! Thanks! Rich

If possible, when the weeds die down, take a garden rake back in there and rake up as much as the surface stuff as possible. Find all the clad and other interesting stuff and get rid of the trash and maybe that will help cut down on the amount junk you have to contend with when you start clearing it out with the detector. When you get done just cover it up with the leaves that are were there so no one will know you have been clearing it out. GL and HH