I know they dont mean much but I would like to see what some others are getting in an air test with your atpro. Below are mine from my new pro(the model with the camlocks) and I have to say my early model atpro that I sold air tested better than the new one I have by a couple inches on average. It would air test a quarter at well over 12" and have a steady repeatable signal. My new one is struggling at 10". This is with the stock 8.5x11 coil,pro mode zero with no disc and full sensitivity and GB set at 80. I did this at a brisk sweep speed to try and simulate the speed I would be swinging with. I know I could eek out a little more if I flew back and forth across the coil but that wouldnt be how I would be swinging in the real world. I stopped as soon as the signal didnt repeat steadily.
clad Silver
.01=9" .10=9"
.05=10.5" .25=9.5"
.10= 9" .50=10"
.25=10"
Since it is my only machine now, I would like to see if I am in the average or if I should have it checked out by garrett. Their customer service is awesome so I have no worry with that but I dont want to bother if it is in the range of everyone elses. It just seems like it is way less sensitive than my other pro was. I also have dug about 12 coins so far with it but nothing over 3" deep.
clad Silver
.01=9" .10=9"
.05=10.5" .25=9.5"
.10= 9" .50=10"
.25=10"
Since it is my only machine now, I would like to see if I am in the average or if I should have it checked out by garrett. Their customer service is awesome so I have no worry with that but I dont want to bother if it is in the range of everyone elses. It just seems like it is way less sensitive than my other pro was. I also have dug about 12 coins so far with it but nothing over 3" deep.