walleyecrazy
New member
I went to my local dealer yesterday and picked up a Treasure Pro. This is my first Whites detector and so far I am impressed. I have been using the TRX pinpointer for the last six months and loved it so much I figured I'd try one of their detectors. Ive only used it in my back yard so far but the results so far are pretty promising. I've hit my yard pretty hard in the past with a Fisher F2 and a Garrett AT Pro so I thought I had pretty much pulled all the non junk targets out of the pretty small area. To my surprise I was getting some nice high tones in spots where I new I had definitely hit multiple times with the AT Pro. I dug three spots and recovered a penny and two nickels. In each of these holes these coins were actually sitting under a junk piece of metal. I can only think that the good signal was masked and disrcriminared out when I used the AT Pro as I usually ran with Iron discrimination set to about 20 on that machine. I was running the Treasure Pro in Coins & Jewelery mode so it too was running with with iron discrimination yet it was able to pick out these targets where my AT Pro was not. That was pretty impressive to me, and gets me excited to get out and use the Treasure Pro on a good location. My one and only complaint so far is that I wish the lower rod was a little longer. I'm a pretty tall guy at 6'4" and the detector is a bit on the short side for me but still usable until I can get the longer lower rod ordered.