Lake Hunter
Member
I have had no problems with my Etrac until today. Me and a friend were hunting a newly disced lot with our Etracs and ran into a problem right away. We couldn't hardly find any good targets over the nulling, so we ran a magnet through the ground and found alot of bad ground ..... mineralization and very tiny iron fragments, etc. It was so bad that even if we found a clean spot and placed a coin in a hole, the Etrac would pick it up but when we covered the hole, we could only pick it up in the pinpoint mode. I had the Etrac running basically wide open in quickmask, low sensitivity, tried manual and auto sen at times, multitone and also tried 2 tone ferrous. I have never had this happen before. I know there must be an easy fix, but I am not experienced enough with the Etrac to know what it is. Any info would be appreciated.
Thanks, Darryl
Thanks, Darryl