And here we go again, is it possible that if I take a new metal, the first thing I do is change the battery pack? E 'stronger than me, I hate the stylus and then having a number of spare batteries also have to find the method to use them: D: D
The beauty of lithium is that if they are good and give them good their energy until all of a sudden just say, not as the alkaline and nimh that his pants fall slowly.
Unfortunately the battery compartment of the Tejon is not suitable to contain three lithium ex computer, so I had to fall back on an additional container, so as not to change too much metal, I prefer to keep the original as possible, looking in the various drawers I found a little box that I wanted use for a mini model of a Tiny (metal impulse) project was abandoned, the measures are at the limit but remain precisely in the shape of the wings of support between the battery compartments, the measures 80x60x40 mm, I had to paint it because it was white clashed like crazy, the box is secured with four small screws, then you have to make a hole 4 mm from the box to the neck tube to allow the wires to reach the two battery compartments, the positive and negative wires must be brought to everyone in the right compartment holder and connected to the contact welding, this operation requires that the contact is pulled gently from its housing and put in place after welding.
The link to the new batteries will be based on an RJ45 network cable taken from a LAN side there will be a metal socket rj45, I chose this type of connector because it allows me to connect all three individually and then recharge the batteries separately, however the pictures are more explicit, if someone intends to replicate the change, be careful of the polarity.
Throughout this maneuver, however, saves 40 grams compared to original battery packs and earn several hours of searching in more
The beauty of lithium is that if they are good and give them good their energy until all of a sudden just say, not as the alkaline and nimh that his pants fall slowly.
Unfortunately the battery compartment of the Tejon is not suitable to contain three lithium ex computer, so I had to fall back on an additional container, so as not to change too much metal, I prefer to keep the original as possible, looking in the various drawers I found a little box that I wanted use for a mini model of a Tiny (metal impulse) project was abandoned, the measures are at the limit but remain precisely in the shape of the wings of support between the battery compartments, the measures 80x60x40 mm, I had to paint it because it was white clashed like crazy, the box is secured with four small screws, then you have to make a hole 4 mm from the box to the neck tube to allow the wires to reach the two battery compartments, the positive and negative wires must be brought to everyone in the right compartment holder and connected to the contact welding, this operation requires that the contact is pulled gently from its housing and put in place after welding.
The link to the new batteries will be based on an RJ45 network cable taken from a LAN side there will be a metal socket rj45, I chose this type of connector because it allows me to connect all three individually and then recharge the batteries separately, however the pictures are more explicit, if someone intends to replicate the change, be careful of the polarity.
Throughout this maneuver, however, saves 40 grams compared to original battery packs and earn several hours of searching in more