vid numbers jumping around.

[Nock]

Was making some settings using 2tone ferros, then moving around in my backyard i noticed that that cursur was jumping quit abit and even when i placed the coil on the ground and not moving it the numbers still was changing , any comments appreciated.

 

[Sailorman]

Those can be what are referred to by some as an "iffy" target. It could be multiple targets under the coil. It could be something ring shaped on edge or with an unusual complex shape. Could be trash. Could be a good target deep with some small junk nearby. Some people ignore them, some people dig them. There's only one way to find out though......

 

[Meditech]

Your sensitivity could be to high also try lowering it a bit

 

[hershey1]

When running a more open screen numbers tend to jump around more especially with deeper targets, Pay more attention to the CO numbers with good tones. Dig those iffy targets with good CO numbers for sure. Mineralization and trash can effect sounds and numbers. Like was mentioned above you about have to dig a lot of targets in question. You will be surprised more times than not on those iffy targets. HH