What's everyone run in auto sensitivity

[pointer80]

Hi all, just curious what does every ones machine run in auto sensitivity? Alot of times I can get 22-23 in auto +3. Sometimes it will go down to 19 or so in my ground. What does everyone average?

 

[sugar]

i have done my pasture in auto and it sometimes runs at 27 plus 3 so gets quite deep now i have taken most of the goodies i have started practising with manual i have been looking at the suggested level and creeping it up 2 or 3 notches when i get a hit i sometimes go back to auto and on the more deeper targets i dont get a peep but i do need to study more to perfect it hope that helps

 

[reltolbert]

I've had readings as high as 29-30 in clean ground and 20-24 in junk ground. I average about 26-28.

 

[NebTrac]

Most of the time in Auto +3 I will run in low to mid 20's. I've also seen it maxed out in Auto and have had it run as low as 13 or so when hitting cinder paths or coal loadouts at old schools.

NebTrac

 

[ryanchappell]

15-19 at Auto +3. As low as 8 and as high as 23-25 in wood chips, sand or rare good soil sites.

 

[squirrel1]

Mine runs 21-28 in Auto plus 3 depending on the site. I have found several shallow coins in high trash using auto versus using manual running warm to hot.

 

[Goes4ever]

anywhere from 19 to 31

 

[1goldsniper]

east of the Rockies in Mt mine peaks at 10-11 and I have seen it running down to 2 or lower. Running in auto +3

 

[Tenspeed]

Wow, we must have bad soil here in the southeast, but not as bad as 1goldsniper.

I see levels as low as 10-11 and as high as 22-23 depending on where I am. It varies with the soil as I hunt and different areas of the same location can cover the whole range.

I vary mine from Auto plus 0 to plus 3 depending on what the soil is like. I have even being playing with manual settings on occasion.

 

[pointer80]

Does the sesitivity level go by just ground condition or is it also effected by emi?

 

[DETECTORMAX]

i use it almost in manual mode and change it to best sens but i look the auto sensivity bar (right bar ) to find what's the best sensivity

some times i use auto +3 to -2 according the soil condition and erratic noise