I was a little worried about my decision to go with the Safari. When I put it together, it felt a little heavy, but it does weigh 2 pounds less than my Whites 6000di pro sl. I did some air tests on different targets in both ferrous and conductivity tones. I then planted some coins in the sod, ground still frozen in back yard so I couldn't bury them. I practiced pinpointing. Very different from what I was used to. I thought I was going to have some trouble with this.
I had read the manual several times before even purchasing the safari and I read the Quattro book the night I received the detector.
Still a little apprehensive about my decision, I headed to an old park that has been hunted a lot. I had already set up a coins program and crossed saved it to the Relic mode so I would have conductivity tones with only numbers for the TID. I set the sensitivity at 14 although I could have set it higher, I wanted to start at a lower setting. I started out with Trash Density set at low per Andy's suggestion in the book.
Discrimination was set at reject -10 to -1 and +40
I only dug targets that registered at 14, 15 and 30 on up.
I just wanted to get a feel for the sounds and pinpointing. I started digging coins right away and pinpointing was a lot easier than I expected. It was very precise. I left it in Low Trash Density for the most part as the area was not too trashy, but then noticed the threshold blanking a lot in one area and then changed to High. I did a Noise Cancel again. High Trash Density setting really does make the detector act differently. Right away I was picking up a couple of coins mixed in the trash that I missed in Low Trash Density. Andy said in the book that Low Trash Density makes the TID more stable and that is definitely true as in High the numbers did bounce a little but it was not difficult to pick out the good targets based on the tone.
All in all in was a pretty good first outing as I found 2 Quarters, 7 dimes, 5 Pennies, a 1918 and a 1939 Wheatie, a 1941 Nickel, a 1938 Buffalo Nickel and a Sterling Silver ring. The inside of the ring reads Sterling-U-Made in USA.
After just a few hours use I gotta say the Safari is a keeper. I love this detector. I love the sounds it makes, the TID and the weight isn't as much of an issue as I thought it would be. The two wheaties I dug were 8 inches down and the tone was right on. I used my trowel to make a visual mark at how deep they were when I finally got down to them and measured it when I got home. I have a feeling I will be digging coins deeper than I am used to. May have to get a Back Hoe.
I can't wait to get out again.
Here are a few pics of the ring I found. Nothing special, but I was pretty excited to get a ring the first time out.
[attachment 151634 SilverRing001.jpg] [attachment 151635 SilverRing002.jpg]
[attachment 151636 SilverRing003.jpg]
Dan C
I had read the manual several times before even purchasing the safari and I read the Quattro book the night I received the detector.
Still a little apprehensive about my decision, I headed to an old park that has been hunted a lot. I had already set up a coins program and crossed saved it to the Relic mode so I would have conductivity tones with only numbers for the TID. I set the sensitivity at 14 although I could have set it higher, I wanted to start at a lower setting. I started out with Trash Density set at low per Andy's suggestion in the book.
Discrimination was set at reject -10 to -1 and +40
I only dug targets that registered at 14, 15 and 30 on up.
I just wanted to get a feel for the sounds and pinpointing. I started digging coins right away and pinpointing was a lot easier than I expected. It was very precise. I left it in Low Trash Density for the most part as the area was not too trashy, but then noticed the threshold blanking a lot in one area and then changed to High. I did a Noise Cancel again. High Trash Density setting really does make the detector act differently. Right away I was picking up a couple of coins mixed in the trash that I missed in Low Trash Density. Andy said in the book that Low Trash Density makes the TID more stable and that is definitely true as in High the numbers did bounce a little but it was not difficult to pick out the good targets based on the tone.
All in all in was a pretty good first outing as I found 2 Quarters, 7 dimes, 5 Pennies, a 1918 and a 1939 Wheatie, a 1941 Nickel, a 1938 Buffalo Nickel and a Sterling Silver ring. The inside of the ring reads Sterling-U-Made in USA.
After just a few hours use I gotta say the Safari is a keeper. I love this detector. I love the sounds it makes, the TID and the weight isn't as much of an issue as I thought it would be. The two wheaties I dug were 8 inches down and the tone was right on. I used my trowel to make a visual mark at how deep they were when I finally got down to them and measured it when I got home. I have a feeling I will be digging coins deeper than I am used to. May have to get a Back Hoe.
I can't wait to get out again.
Here are a few pics of the ring I found. Nothing special, but I was pretty excited to get a ring the first time out.
[attachment 151634 SilverRing001.jpg] [attachment 151635 SilverRing002.jpg]
[attachment 151636 SilverRing003.jpg]
Dan C