Strange question, but it has me wondering. Is there an ID difference between having the coil stationary in Pinpoint Mode (set to Sizing) and touching the ground verses 1-inch above?
On some targets I`ve noticed a difference.
On weak/deep targets, when the coil is touching the ground the target ID changes--goes to a variable 1 Ferrous. When the coil is 1-inch above, the machine gives vastly different readings.
Is the proper way to keep the coil 1-inch above?
Thanks!
On some targets I`ve noticed a difference.
On weak/deep targets, when the coil is touching the ground the target ID changes--goes to a variable 1 Ferrous. When the coil is 1-inch above, the machine gives vastly different readings.
Is the proper way to keep the coil 1-inch above?
Thanks!